Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: [Resolved] Gauge Tolerances

[Resolved] Gauge Tolerances 2 years 2 months ago #1281

  • JohnRP
  • JohnRP's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 7
  • Thank you received: 0
Hi Al. Perhaps I have missed the area where this may be accomplished but it would be really great if there was a specified area for the actual gauge tolerance criteria. Example - for a 0 to 1" outside micrometer the acceptance criterion for the gauge tolerance is +/-.001. This would satisfy one of my ISO auditors for sure. The tolerance entered would not have to act upon acceptance or rejection but just provide an area for the acceptance tolerance. Considering that the column header text cannot be edited that leaves only one choice, add unedited tolerance dimensions in a UDF (User Defined Field) Text column which really doesn't address the original request to have a "Tolerance" column for any given gauge.
Last Edit: by Al Weisenborn.
The topic has been locked.

Gauge Tolerances 2 years 2 months ago #1288

  • Al Weisenborn
  • Al Weisenborn's Avatar
  • Offline
  • Administrator
  • Administrator
  • Posts: 293
  • Thank you received: 2
Hello John,

You can use any of the user defined fields on the More Info Tab. You can easily change the names of these fields by using the Translator screen that can be accessed from the Tools Menu
The topic has been locked.
  • Page:
  • 1
Time to create page: 0.087 seconds